Ericsson DUAL FORMAT MDR, Installation Manual, Page: 9 / 28

GROUP 14
P1 & P2
FUNCTION GROUP 18
P1 & P2
1 A- 1
2 SPEAKER LO 2
3 SPEAKER HI 3
4 MIC HI 4
5 SW A+ 5
6 SERIAL REQUEST (GE STAR) 6
7 PTT 7
8 CG DISABLE 8
9 SW SPEAKER HI 9
10 AUDIO MUTE 10
11 VOLUME-SQUELCH HI 11
12 MIC LO 12
13 RELAY 13
14 SPARE 14
DISPLAY SERIAL 15
KEYPAD SERIAL 16
Table 2 - Option Cable Connections
POWER CABLE - OPTION PMCD9A
Refer to the power and ignition cable installation to install this optional power
cord.
NOISE SUPPRESSION KIT - OPTION PMPD1A
Refer to the noise suppression kit option installation manual that is included
with this option and the interconnection diagrams at the back of this manual.
ALARM (HORN) RELAY KIT - OPTION PMSUIC
Requires the use of option cable kit - option PMCC3N. The alarm relay kit
option consists of the following items:
20
Figure 2 - Typical Hump Or Dash Mount
For passenger safety, mount the radio securely so that the unit will not
break loose in the event of a collision. This is especially important in
station wagons, vans and similar type installations where a loose radio
could be extremely dangerous to the vehicle occupants.
WARNING
INSTALLATION IN VEHICLES POWERED BY
LIQUEFIED (LP) GAS
Radio installation in vehicles powered by liquefied petroleum gas with the
LP-gas container in the trunk or other sealed-off space within the interior of the
vehicle must conform to the National Fire Protection Association Standard NFPA
58 which requires that:
••
Space containing radio equipment shall be isolated by a seal from the
space containing the LP-gas container and its fittings.
••
Outside filling connections shall be used for the LP-gas container.
••
The LP-gas container space shall be vented to the outside of the vehicle.
MOUNTING LOCATION
9