17 of 19
888-24-227-G-01 rev. E • 12/19
=
1
4
mm
APPENDIX A - M
inimi
z
e
L
i
ft T
ension
W
AR
N
I
NG.
Before removing mounted equipment (monitor, arm, stand CPU, etc.), from desk, or
to prepare for shipping or storing the desk it is extremely important to minimize the lift tension.
Failure to install these instructions may cause lift engine to expand rapidly and may result in
equipment damage and or personal injury.
Turn
ad
j
ustment
b
o
l
ts
l
eft
to
minimize
tension
.
W
AR
N
I
NG!
DO
N
OT
tip
desk
over
to
ad
j
ust
.
On
ly
perform
ad
j
ustment
whi
l
e
desk
is
upright
.
Fai
l
ure
to
fo
ll
ow
these
instructions
ma
y
cause
the
l
ift
engine
to
e
x
pand
rapid
ly
and
ma
y
resu
l
t
in
e
q
uipment
damage
and
or
persona
l
in
j
ur
y.
Make
sure
covers
are
fu
lly
c
l
osed
b
efore
l
owering
the
worksurface
.
N
OTE:
The covers on the legs will not open unless
the worksurface has been lifted to it’s full height. The
worksurface will not lower unless the covers have been
completely closed.
1.
Release the hand brake (on the right leg) and move the worksurface up to
highest level.
2.
Push in the cover located behind each leg to access the adjustment point.
3.
To minimize tension, turn adjustment bolts left using a 14mm
socket drill. Maintain equal tension on both legs by alternating
adjustment from one leg to the other. Keep adjusting until the
wrench stops turning.
4
.
Once at minimum tension it is ok to remove mounted equipment.