6 of 8
300-5577-00 rev. J • 10/16
M6-20 Cap Screw
325-5272-00
Nylock Nuts
325-5186-00
1/2”Button-hd Screw
325-5193-00
48w Table
Shown without Control Box for easier view.
Side View
S t e p 5 - I N S TA L L C A B L E T R AY
Align the Cable Tray with the back of the table so the holes on the threaded posts on the cross pan line up with
the holes on the cable tray. Attach the tray to the pan with three Nylock Nuts using your own 3/8" socket or the
3-way wrench provided. (The plastic end of the nut faces up.)
Connect a 1-meter Control Box Cable to each leg cable, then plug each into a port on the Control Box through
the opening in the support pan. Feed extra cable length through an opening in the support pan so it's organized
in the Cable Tray.
Route the Keypad's cable back to the Cross Pan and plug it into the Control
Box. Feed extra cable length through an opening in the support pan so
it's organized in the Cable Tray.
Plug the Power Cord into the Control Box.
Use the provided cable clips to route and organize cords. Install one cable
clip next to the Leg Gusset for the Keypad Cord. Install the other clip next
to the Cross Pan for the Control Box Cables.
S t e p 6 - I N S TA L L F E E T A N D H O M E T H E L E G S
Align one foot with each leg so the wheels are at the back. Attach the foot
to the leg with four M6x20 Socket-head Screws using the Anthro driver.
Repeat for the other foot.
With the help of another person, carefully rotate the table onto its feet. Plug
in the table and use the keypad to move the table all the way down.
Release the button and press it again to home the legs so they move in
unison.
Add your equipment and route cords into the cable tray. Carefully move the
table through its entire range of motion to be sure that your power and
data cables are long enough.
CO N G R AT U L AT I O N S ! YO U R E L E VAT E I I A S S E M B LY I S CO M P L E T E !
