8 of 18
3
MM
MM
MM
888-60-513-P-01 rev. D • 09/19
Test Fasteners
It is important that you test the chosen
fastener combination to be sure it is
the right size for your display: partially
thread the screw into the display by
hand with the correct combination
of washers and spacers (do not fully
insert and do not tighten screw at this
time). If you feel resistance, remove the
screw immediately and check to see
if a screw with a better matching size
has been provided. If you are unable
to fi nd an appropriate sized screw for
your display, contact Ergotron Custom-
er Care. If the chosen combination of
fasteners is correct for your situation,
mount the display brackets to your
display as instructed in the provided
Tilt Mount Assembly manual.
测试紧固件很重要的一点是,要
测试紧固件组合的选择,保证其
尺寸正好适用于您的显示器:手
将螺丝与显示器进行部分啮合,
垫圈和衬垫的组合要正确(此时
不要全部插入 ,不要拧紧螺丝)
。如果感觉有抗力,要立即拆除
螺丝,检查看看是否提供了更合
适尺寸的螺丝。如果无法为您的
显示器找到合适尺寸的螺丝,
请联系 Ergotron 客户服务部。
如果所选择的紧固件组合适合您
的情况则按照倾斜安装中的说明
,将显示器支架安装到您的显示
器上。
고정 장치 테스트
선택한 고정 장치 조합을
테스트하여 디스플레이에
맞는 크기인지 확인하는 것이
중요합니다. 특히 올바른 와셔와
스페이서를 사용하여 손으로
디스플레이에 나사를 끼우십시오.
이번에는 완전히 삽입하지 말고
나사를 조이지 마십시오. 빡빡한
느낌이 들면 나사를 즉시 빼고 더
잘 맞는 크기의 나사가 있는지
확인하십시오. 디스플레이에 맞는
적절한 크기의 나사를 찾을 수
없는 경우 Ergotron 고객 지원
부서에 문의하십시오. 선택한 고정
장치 조합이 잘 맞으면 디스플레이
브래킷을 제공된 기울기 설치 조립
설명서의 지침에 따라 디스플레이에
설치하십시오.