8
3.3 Adjusting the Hera II
The chair should be adjusted to the individual user on delivery.
Setting the seat height
:
Setting the seat height is carried out without tools, it is not meant to be used on a daily
basis.
1)
Release the spring-loaded screw on both sides and turn
these so that they rest against the outer surface. The seat
can now be raised until the desired height is reached.
2)
Turn the spring loaded screw so that it engages again.
Note:
The spring loaded screw MUST be engaged before using the
chair again.
PU-Back support:
The back support will automatically angle itself according to the
pressure of the user.
It can also be moved up or down to suit individual needs.
1)
Loosen the screws on the brackets, placing the unit at the
correct height and tightening the screws again. (This does
not apply to the fabric back).
Foot supports:
1)
Remove the clips and adjust the foot support to the
required height.
2)
If the foot supports can be angled, the support can be
pulled out to the required angle and will lock
automatically.
3)
By releasing the small (black) handle the foot support can
be lowered.
Neck support
:
1)
Use the hand screw to adjust height and angle.
Armrests:
1)
The armrests can be raised to allow sideways transfer.
Note:
Ensure that the user´s arms cannot be trapped or squeezed during this operation.
Summary of Contents for Hera II Maxi/250
Page 2: ...2...
