3B-1
Position the wall wall plate [01]
or [01 and 02] at your desired
height, level the wall plate and
mark the pilot hole locations.
3B-2
3/8 in.(ø10mm)
2 9/16 in.(65mm)
Drill 4 pilot holes using a 3/8 in.
(10mm) diameter drill bit. Make
sure the depth is not less than
2 9/16 in. (65mm). Never drill
into the mortar between blocks.
3B-3
Use the hammer to knock
anchors [A3] into the wall. Be
sure the anchors [A3] are seated
flush with the concrete surface.
A3
3B-4
Install the wall plate [01] or [01 and
02] using lag screws [A1]. Tighten
the lag screws [A1] only until the
washers [A2] are pulled firmly
against the wall plate. DO NOT
over-tighten the lag screws [A1].
A1
A2
3/8 in.(10 mm)
Socket Wrench
(Not included)
09
