Erco&Gener GENPRO 40E R2, User Manual

Page: 9 / 57

EG_GenPro40e-R2_1006_UG_001_UK.doc Page 9 / 57
Descriptions and non-contractual illustrations in this document are given as an indication only.
ERCOGENER reserves the right to make any modifications.
Dct_427_02
Warning
•
ERCOGENER recommends to read carefully all documents about the product GenPro 40e (User
Guide, Application notes, Command List).
•
ERCOGENER cannot be held responsible for:
- The problems due to an inappropriate use of the GenPro 40e .
- The problems due to a wrong configuration
- The problems due to a wrong use of an embedded software application developed or
supplied by a third party.
- The dysfunctions due to the absence or a bad coverage of the GSM, GPRS networks.
•
The dysfunctions if the product is used for the watching of physical persons where human life is
engaged.
•
ERCOGENER reserves the right to modify the functions of its product "GenPro 40e " without
previous notice.
- To avoid any risk of electrocution, do not open the casing.
- For any functioning, the casing must be closed.
- No internal part can be repaired by the user. The GenPro 40e must be returned to the factory for any
repair.
- The GenPro 40e must be placed in a normally ventilated area, out of sources of heat.
- In order to guarantee the electromagnetic compatibility, the length of the serial cable, the power supply
cable, and the inputs/outputs cable must not exceed 3 meters.
- The GenPro 40e must not be connected directly to the mains supply; a voltage adapter must be used.
This product complies with the European Directive 2002/96/CE.
SCRAP THIS PRODUCT ACCORDING TO THE CORRESPONDING LOCAL REGULATIONS
REGARDING RECYCLING NON DANGEROUS FOR THE ENVIRONMENT.