background image

Flying Your Model

Your model has been designed for the intermediate modeler 

who is familiar with the use of a four-channel radio system.  

It is available in Mode 1 and Mode 2.  Always perform a 

range and flight check to make sure all controls are operating 

properly before flying your model. 

Range check:

Connect the Li-Poly battery to the aircraft, before turning on 

the TX press CH3-, keep the button pressed down and turn 

on the transmitter.  You will hear 5 consecutive tones, you are 

now in range check mode.  10 metres distance from the model 

in range check mode is equivalent to around 100 metres 

range in normanl flying mode.  Move the transmitter sticks to ensure all channels are working.  To return 

to normal flying mode turn off the transmitter and turn it back on again, you will hear 3 beeps to confirm 

you are back in normal flying mode.

Setting the trim before flight

It may be neccessary to fine trim your model before flight, with all transmitter sticks in neutral all control 

surfaces should be at neutral position.

   

DIGITAL TRIMS:

CH2: 

Elevator trim buttons 

(+ for up and - for down)

CH3: 

Throttle trim buttons 

(+ for increase and - for decrease)

CH4:

 Rudder trim buttons 

(+ for right and - for left)

Ch1 -

Ch1 +

Ch4 - Ch4 +

Ch3 -

Ch3 +

Ch2 -

Ch2 +

Mode 2

Ch1 -

Ch1 +

Ch4 - Ch4 +

Ch2 -

Ch2 +

Ch3 -

Ch3 +

Mode 1

Servo reverse

Servo directions are factory set and should move in the correct direction.  To reverse servo direction 

follow this procedure:

Ch2 Elevator servo reverse:

 Press Ch1+ and Ch2+ or - simultaneously

Ch4 Rudder servo reverse: 

Press Ch1+ and Ch4+ or - simultaneously

Reviews: