Erbauer ERI691COM, Original Instructions Manual

Page: 18 / 28

Light ON/OFF
flash
Status
Red on
Defective Battery
Red flash
- - - - -
Battery Temperature Protection
The temperature of battery
pack is less than 0
o
C or more
than 45
o
C.
Green on
Fully Charged
Green
flash
- - - - - - Charging
2. TO REMOVE OR INSTALL THE BATTERY
PACK (SEE Fig. B1, B2)
Depress the battery pack release button to release
and slide the battery pack out from your tool. After
recharge, slide it back into your tool. A simple push
and slight pressure will be sufficient.
NOTE: please make sure every half year
recharger battery pack one time if the battery
pack stock long time.
NOTE: If battery pack over discharged, At this
time charging directly charger red light could
be lighting, please remove battery pack from
charger and standing it for a period time before
recharge.
3. HOW TO USE THE BELT CLIP (SEE FIG.C1 C2)
Screw the Belt clip(5) on the tool with the screw
(not provided). The Belt clip can be hooked on your
belt or pocket, etc.
OPERATION
1. ON / OFF SWITCH (SEE Fig.D)
Depress the On/Off switch (9) to start and release
it to stop your drill. The on/off switch is fitted with a
brake function which stops your chuck immediately
when you quickly release the switch.
It is also a variable speed switch that delivers
higher speed and torque with increased trigger
a
REVERSE
OFF position
FORWARD
b
Fig. J
Fig. K
Fig. I
Fig. H
Fig. G
Fig. F2
Fig. F1
Fig. E
Fig. D
Fig. A
Fig. B1
Fig. B2
Fig. C2
Fig. C1