23
22
FUNCTION MODE SELECTION
The operation of the gearbox for each application is set with the function mode selection
switch (4). To change between functions, depress the unlocking button and rotate the
selector to the desired operating mode.
For impacting only - for light chipping, chiseling and demolition
applications choose the Hammer position.
For drilling into steel, wood and plastics choose the Rotary drilling
position.
For simultaneous drilling and impacting of concrete or masonry,
choose the Hammer drilling position.
Adjustable working angle when using flat chisel.
(The tool must not be operated when the switch is in that position)
WORKING HINTS FOR YOUR HAMMER
If your power tool becomes over heated, set the speed to maximum and run no load for 2-3
minutes to cool the motor. SDS-plus tungsten carbide drill bits should always be used for
concrete and masonry.
When drilling in metal, only use HSS drill bits in good condition. Where possible use a
pilot hole before drilling a large diameter hole.
USE
01
INTENDED USE
The machine is intended for hammer drilling in concrete, brick and stone as well as for
light chiseling work. It is also suitable for drilling without impact in wood, metal, ceramic
and plastic.
02
OPERATION
ON/OFF SWITCH WITH VARIABLE SPEED CONTROL (E)
Depress the ON/OFF switch (6) to start and release to stop your tool. This tool has a
variable speed switch
(6) that delivers higher speeds with increased trigger pressure - speed is controlled
by varying the pressure applied to the switch.
FORWARD AND REVERSE ROTATION CONTROL (F1, F2)
With the drill pointing away from you, push the forward/reverse rotation control (5) to
the left for forward rotation. Push the forward/reverse rotation control (5) to the right for
reverse rotation
WARNING!
Never change the direction of rotation while the tool is
rotating, wait until it has stopped.
SWITCH LOCK (F3)
The switch trigger can be locked in the OFF position. This helps to reduce the possibility
of accidental starting when not in use. To lock the switch trigger, place the rotation control
(5) in the centre position.
