ERBAUER 254MM (10”) DOUBLE BEVEL SLIDING MITRE SAW
8. Compound cut
A compound cut is the combination of a mitre and
a bevel cut simultaneously.
1) Loosen the bevel lock handle (1) and position
the cutting head at the desired bevel position. Lock
the bevel lock handle.
2) Loosen the mitre handle (2). Press down the
positive stop locking lever (3) and position the table
at the desired angle. Release the positive stop
locking lever and lock the mitre handle.
(See fig. 32)
IMPORTANT
When cutting a maximum RH or LH compound
cut (mitre at 45˚ bevel at 45˚) move the RH or
LH fence extension by first loosening the locking
screw (A) and secondly pulling the locking pin
(B) and sliding the extension away from the
cutting area (C). (See fig. 32)
9. Slide cutting wide boards up to 300mm wide
WARNING!
To avoid injury:
• Never pull the cutting head assembly and
spinning blade toward you during the cut. The
blade may try to climb up on the top of the
workpiece, causing the cutting assembly and
spinning blade to kick back, forcefully. The cutting
head assembly should be drawn back completely
then pushed forward when sawing.
• Let the blade reach full speed before cutting. This
will help reduce the risk of a thrown workpiece.
Fig 32
1
2
3
B
A
C
