Erbauer ERB567DRH, Manual

Page: 14 / 22

OPERATING INSTRUCTIONS
Note:
Before using the tool, read the
instruction book carefully.
NTENDED USE
The concrete breaker can be cut crushing asphalt,
grooving and squaring, ram tamping sand and
gravel, dig ground in various foundation, etc. The
machine uses a single phase alternating current
230V, 50Hz motor, its compact and robust format
makes it versatile and efficient for uses described
in specific safety instructions. It complies to current
regulations and the optimum quality of materials
used will ensure a long working life in complete
safety.
For low temperatures, new power tool or long-
time storage, the machine reaches the full
impact rate only after a certain time.
This start-up time can be shortened by striking
the chisel in the machine against the floor one
time.
Point chisel (For gravel)
Total length: 400mm
Standard size: 30mm (Hexagon)
Flat chisel (For crushing asphalt, grooving and
squaring)
Total length: 400mm
Standard size: 30mm (Hexagon)
1. DUSTPROOF COVER (See Fig. 1)
Before chiseling vertically fit the Dustproof cover
over the drill bit.
Caution:
Always wear eye protection with this
tool.
2. FITTING THE CHISEL (See Fig. 2)
1) Insert the chisel into the chuck.
Fig. 6-1
Fig. 1
Fig. 3
Fig. 2
Fig. 4
Fig. 5
Fig. 6-2
Fig. 7
1
Loosen
Loosen
Tighten
Tighten
2