700W HVLP SPRAY GUN ERBAUER
Possible cause
Solution
7. Paint pattern centre
narro
7.1 Not enough paint in the
cup or viscosity too low
7.2 Fluid output
7.1 Refill paint, mix
viscosity according to
manufacturer
recommendation
7.2 Adjust fluid output
8.
Uneven paint pattern
8.1
Mix viscosity according
to manufacturer
recommendation
8.2 Adjust fluid output
Problem
8.1
Viscosity too high
8.2 Fluid output
13. Recycling and disposal
The product comes in a package that protects it against damage during shipping.
Keep the package until you are sure that all parts have been delivered and the
product is function properly. Recycle the package afterwards.
Old products are potentially recyclable under WEEE and do not, therefore, belong in
your household rubbish. You are requested to assist us and our contribution to saving
resources and protecting the environment by handing in this appliance at an equipped
collection centre (if there is one available).
Dispose of paint and thinning agent in closed containers at a suitably authorised
disposal company. Take account of national and local disposal regulations.
14. Power cord
If the power cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a safety hazard.
4. Fluttering or spitting
4.1 Not enough paint in
the cup
4.2 Container tipped too
far
4.3 Spray nozzle loose,
worn or damaged
4.4 Dry, worn or damaged
needle
4.1 Add paint
4.2 Hold more upright
4.3 Tighten or replace
spray nozzle
4.4 Lubricate or replace
needle
5. Paint pattern curvy
5.1 Spray nozzle worn or
loose
5.2 Spray head plugged up
5.1 Tighten spray nozzle or
replace
5.2 Clean or replace spray
head
6. Irregular paint pattern
6.1 Spray head plugged up
6.2 Spray nozzle dirty or
worn
6.1 Clean or replace spray
head
6.2 Clean or replace spray
nozzle
