Erbauer ERB379PLN, Original Instructions Manual

Page: 17 / 25

4MM PLANER
10
7
14
10
7
14
10
7
14
Fig. 13
Fig. 14
Fig. 15
direction of cut as well as how the tapered edge of
the old blades are oriented. The tapered edge of the
new blades must be in the same orientation as the
original blades.
Using your finger press the safety cover down, then
using the tip of a spanner (or screwdriver) to push
blade out of the drum and then remove.
Note: If a blade cannot be pushed out of blade drum
easily after loosening screws, use a block of wood
to break the blade loose from the blade holder, with
a short sharp blow. Then push with a screwdriver to
remove the blades. If necessary, tap block of wood
sharply with a small hammer to break blades loose.
Clean any saw dust or wood chips from around the
blade area.
Slide new blade into the slot of the blade drum.
Use a spanner (or screwdriver) to push the blade
into the blade drum until it is centred into position.
Using the blade spanner, retighten the three blade
installing screws.
Repeat the above procedure to change the other
blade.
After blades are replaced, check that blades are
parallel and same surface as the rear base plate
with ruler. If not, you can adjust the blades with
hexagonal wrench provided. To adjust the blades,
firstly loosen the three screws on the blade holder.
Then turn clockwise the socket head screw, the
blade will be risen, turn anti-clockwise the socket
head screw, the blade will be lowered down. Finally
retighten the three screws fully.
10. DRIVE BELT REPLACEMENT
(See Fig.13, 14)
Warning:
1). Remove the plug from the socket before carrying
out any adjustment, servicing or maintenance.
2). The cutting blades will be turning and may
cause injury.
3). Always put on gloves when operation.
Loosen the screw and remove the belt cover.
Remove the worn drive belt from the large pulley
and the pinion and clean them. Lace the new
belt on the top of the pinion and turn it manually,
press it on the large pulley Make sure that the
drive belt runs exactly along the length grooves
of the pinion and the pulley. Replace the belt
cover. Install the cover screw and tighten fully.