ERBAUER 254MM (10”) DOUBLE BEVEL SLIDING MITRE SAW
20. The operator is adequately trained in the use, adjustment and operation and
operation of the machine.
21. Provide for adequate room lighting at your workplace or for adequate lighting
of the immediate work area.
22. When fitted with laser no exchange with different type of laser is permitted.
Repairs shall only be carried out by the laser manufacturer or an authorised
agent.
23. Refrain from removing any cut-offs or other parts of the workpiece from
the cutting area whilst the machine is running and the saw head is not the rest
position.
24. Never stand on this tool. Serious injuries could occur when this tool tips over
or when coming in contact with the saw blade.
25. Only use the saw with guards in good working order and properly maintained,
and in position.
26. Keep the floor area free of loose material e.g. chips and cut-offs.
27. Ensure the speed marked on the saw blade is at least equal to the speed
marked on the saw.
28. Warning. Not replace the laser with a different type. Instruction that repairs
shall only be carried out by the laser manufacturer or an authorised agent.
WARNING:
the operation of any mitre saw can result in foreign objects being
thrown into your eyes, which can result in severe eye damage. Before beginning
power tool operation, always wear safety goggles or safety glasses with side shield and a full
face shield when needed.
WARNING:
If any parts are missing, do not operate your mitre saw until the
missing parts are replaced. Failure to follow this rule could result in serious
personal injury.
Caution:
Do not let familiarity with your mitre saw make you careless. Remember that a
careless fraction of a second is sufficient to cause severe injury.
Double insulation:
The tool is double insulated. This means that all the external metal parts are electrically
insulated from the mains power supply. This is done by placing insulation barriers between
the electrical and mechanical components making it unnecessary for the tool
to be earthed.
Important note
Be sure the supply is the same as the voltage given on the rating plate. The tool is fitted
with a two-core cable and plug. Remove the mains plug from socket before carrying out
any adjustment or servicing.
SAFETY RULES FOR LASER LIGHT
The laser light/laser radiation used is Class 2 with maximum 1mW power and 650nm
wavelength.
These lasers do not normally present an optical hazard, although staring at the beam may
causeflash blindness.
WARNING:
Do not stare directly at the laser beam. A hazard may exist if you
deliberately stare into the beam, please observe all safety rules as follows:
