ERBAUER 254MM (10”) DOUBLE BEVEL SLIDING MITRE SAW
6) When the saw reaches full speed, push the
switch handle down, slowly, cutting through the
leading edge of the workpiece.
7) Slowly move the switch handle toward the
fence, completing the cut.
8) Release the trigger and allow the blade to stop
spinning before allowing the cutting head to raise
to its upper position. (See fig. 34)
10. Cutting bowed material
A bowed workpiece must be positioned against
the fence and secured with a clamping devise
before cutting as shown.
Do not position workpiece incorrectly
or try to cut the workpiece without the
support of the fence. (See fig. 35) This will cause
the blade to bind and could result in personal
injury.
11. Satellite workpiece support
Incorporated into the LH side of the machine base
is a removable satellite stand. Use this stand to
help support long pieces of material. To remove
the satellite stand, press the release button on the
top, and slide the stand from the machine base.
Position where convenient to adequately support
long workpieces.
To replace, simply slide the satellite stand back
into the machine base until the release button
provides positive location. (See fig. 36)
Fig 35
Fig 36
