Erbauer ERB125Y, Manual

Page: 12 / 20

Finally lower the flange cap and re-tighten the
flange cap lock knob and the adjusting channel
depth knob.(see fig12)
3. Adjusting the groove depth
You can adjust the depth of groove simply by
loosening the adjusting channel depth knob and
lowering or raising the base plate to the desired
position .
Re tighten the adjusting channel depth knob after
setting the depth.(see fig13,14&15)
4. Removing the Fixed guard (Alternative
blade fixing method)
In order to clean the internal guard area from
debris you can remove the fixed guard and gain
access to the internal cutting head area.
Firstly completely unscrew and remove the
adjusting channel depth knob and its sight
marker,now using the Allen key supplied undo
the two guard fixing bolts and lift off the fixed
guard.
The base plate can also be removed by sliding it
off the guide wheel pin.
This method can also be used to fix and adjust
the cutting blades.
To re- assemble simply reverse the above
procedure.(see fig 16,17,18,19,20,21,22,23,24&25)
5. Fitting the auxiliary handle
For your own safety we recommend that you fit
the auxiliary handle at all times thus maintaining
complete control of the tool during operation.
To fit the handle locate to the fixed guard and
simply screw into place and secure.(see fig26)
6. Connecting the Dust extraction adaptor
Your wall chaser is fitted with a dust extraction
adaptor.
This has a bayonet joint that will prevent it from
unintentional loosening during operation.
Locate the extraction hose into the adaptor and
ensure it is securely located.
We recommend that you use a suitable dust
extraction method at all times and this will
prevent the build up of debris and possible over
heating of the motor!( see fig 27)
7. Switching ON and OFF
The machine is equipped with a safety lock off
Fig 10
Fig 11
Fig
8
Fig
9