Erbauer ERB112BTE, Handbook

Page: 11 / 19

150MM BENCH GRINDER
OPERATING INSTRUCTIONS
Important:
Ensure that the eye shields, spark arresters and
the work rests are fitted and correctly adjusted
and that you are wearing safety gear including
eye, hearing and breathing protection before us-
ing the tool.
Warning:
Never attempt to grind
Magnesium. Only use the front face of the
grinding wheel but not the sides. Please note
that the work piece can get very warm. It may
be necessary to cool a work piece by dipping it
in a coolant or in water. Do not apply coolant or
water to the grinding wheel.
—Turn the wheel by hand to make sure it does
not touch the guard, eye shields, spark arresters
or work rests and runs freely.
—Stand to one side, turn the switch on and al-
low the motor to reach full speed.
—Support the work piece on the work rest and
gradually feed the work piece onto the wheel.
Note:
Traverse the work piece across the full
width of the wheel to prolong its flat surface.
—If the grinding operation causes the motor
speed to noticeably decrease, pull back the work
piece, allow the motor to regain full speed and
restart the grinding operation, but apply less
force.
1. On/Off switch
To turn the grinder on, press the On/Off switch to
the position marked “I”.
To turn the grinder off, press the On/Off switch to
the position marked “O”.
2. Using the work light (See Fig.F)
The work light can be used to illuminate the
work area and provide greater visibility. It is
controlled by the On/Off switch.
Remove the light protector to replace a new
bulb.
Fig.F