21
20
02
UNPACKING
Unpack all parts and lay them on a flat, stable surface.
• Remove all packing materials and shipping devices, if applicable.
•
Make sure the delivery contents are complete and free of any damage. If you find that parts
are missing or show damage do not use the product but contact your dealer. Using an
incomplete or damaged product represents a hazard to people and property.
• Ensure that you have all the accessories and tools needed for assembly and operation. This
also includes suitable personal protective equipment
WARNING!
The product and the packaging are not children’s toys!
Children must not play with plastic bags, sheets and small parts! There is a
danger of choking and suffocation!
03
ASSEMBLING THE MACHINE
CHARGING YOUR BATTERY PACK
The battery has been shipped in a low charge condition. Charge it fully before first use.
Refer to the charger instruction manual for the details.
TO REMOVE OR INSTALL THE BATTERY PACK (A1, A2)
Depress the battery pack release button to release and slide the battery pack out from
your tool. After recharge, slide it back into your tool. A simple push and slight pressure will
be sufficient.
BATTERY PACK POWER BAR
The Li-Ion battery pack (5) is equipped with a POWER BAR which is used to give an
indication of the battery pack’s remaining charge. Press and hold the POWER BAR
button (6) to check battery charge as below.
6
76-100% Charge
51-75% Charge
26-50% Charge
15-25% Charge
On
Off
USE
01
INTENDED USE
This product is intended for drilling in wood and similar materials e.g. MDF, plywood etc,
plastic, metal, as well as for screw driving.
02
OPERATION
ON / OFF SWITCH (B)
Depress the on/off switch (9) to start and release it to stop your drill. The on/ off switch is
fitted with a brake function which stops your chuck immediately when you quickly release
the switch. It is also a variable speed switch that delivers higher speed and torque with
increased trigger pressure.
WARNING!
Do not operate for long periods at low speed because
excess heat will be produced internally.
SWITCH LOCK (C1)
The switch trigger can be locked in the OFF position. This helps to reduce the possibility
of accidental starting when not in use. To lock the switch trigger, place the rotation control
(4) in the centre position.
FORWARD/REVERSE ROTATION CONTROL (C2, C3)
WARNING!
Only change the rotational direction when the product
is switched off and has come to a complete stop! Always ensure that
the forward / reverse rotation control is adjusted to the correct position
depending on the intended operation!
Always push the forward / reverse rotation control as far as it will go! Do not
use the product with the control switch in any other intermediate position!
Move the forward / reverse rotation control (4) to the left in order to use the product in a
clockwise rotational mode
.
Move the forward / reverse rotation control (4) to the right in order to use the product in
anticlockwise rotational mode.
Summary of Contents for EDD12-Li-2
