21
20
SAW BLADES (B)
Different saw blades can be used with this product depending on the workpiece material.
WARNING!
Always use saw blades according to the intended use! For
example, never use a saw blade intended for working on wood for working
on metal or vice versa!
Observe the technical requirements of this product (see section Technical
specifications) when purchasing and using saw blades!
Some saw blades are very sharp and become hot during use! Handle them
carefully! Wear protective gloves when handling saw blades in order to
avoid injuries like burns and cuts!
Pull out and hold the tool-free blade change lever (10).
Insert a suitable saw blade (13) all the way into the blade socket (12) up to the stop and
release the lever (10).
NOTE:
The blade can be fitted and used in upwards or downwards going
direction.
Pull on the saw blade (13) to test that it is firmly located in place. It should not be possible
to pull it out.
Repeat the first step above to remove the saw blade (13) and insert a new one if
required.
02
UNPACKING
Unpack all parts and lay them on a flat, stable surface.
• Remove all packing materials and shipping devices, if applicable.
•
Make sure the delivery contents are complete and free of any damage. If you find that parts
are missing or show damage do not use the product but contact your dealer. Using an
incomplete or damaged product represents a hazard to people and property.
• Ensure that you have all the accessories and tools needed for assembly and operation. This
also includes suitable personal protective equipment.
WARNING!
The product and the packaging are not children’s toys!
Children must not play with plastic bags, sheets and small parts! There is a
danger of choking and suffocation!
03
ASSEMBLING THE MACHINE
CHARGING YOUR BATTERY PACK
The battery has been shipped in a low charge condition. Charge it fully before first use.
Refer to the charger instruction manual for the details.
TO REMOVE OR INSTALL THE BATTERY PACK (A1, A2)
Depress the battery pack release button to release and slide the battery pack out from
your tool. After recharge, slide it back into your tool. A simple push and slight pressure will
be sufficient.
BATTERY PACK POWER BAR
The Li-Ion battery pack (7) is equipped with a POWER BAR which is used to give an
indication of the battery pack’s remaining charge. Press the POWER BAR button (8) to
check battery charge as below. The LED will stay lit for approximately 5 seconds
.
8
76-100% Charge
51-75% Charge
26-50% Charge
5-25% Charge
under 5% Charge
Flash
On
Off
