21
20
USE
01
INTENDED USE
The product is intended for cutting and trimming of high and wide hedges, bushes and
shrubs. Observe the technical data for the maximum cutting capacity. Do not cut non-
plant material or branches exceeding the stated maximum capacity.
02
OPERATION
ON/OFF SWITCH (FIG. D)
Press the locking off button (8), and then press the on/off switch (9).
Release the locking off button.
To turn it off, simply loosen the on/off switch.
SETTING THE WORKING LENGTH (FIG. E)
WARNING!
Always remove the rechargeable battery before inspection
and adjustment work.
Loosen the telescopic quick-lock lever(5) of the telescopic handle. Push or pull the tube
to adjust the length of the tube. Tighten the quick lock lever when the desired length is
achieved.
NOTE:
Only extend the tube far enough to just reach the hedge and
shrubs.
PIVOTING THE TRIMMER HEAD (FIG. F)
WARNING!
Always remove the battery before inspection and
adjustment work
.
Push the angle adjustment locking knob(3) inward.
Grasp the power head motor housing and rotate the power head to either of the 5 positions
(Fig. F).
Release the locking knob.
It should snap back into a seated position. If it does not, rotate the power head back and
forth slightly until the button snaps back into its seated position. The power head is now
locked into position and ready for use.
PUTTING ON THE SHOULDER STRAP (FIG. G1, G2)
Place the shoulder strap(14) over your left shoulder (Fig. G2).
Fasten the snap hook on the securing clip on the shaft (Fig. G1).
The length of the shoulder strap can be adjusted.
USING THE TELESCOPIC HEDGE TRIMMER (FIG. H-K)
The telescopic Trimmer is a dual- purpose tool. It is designed to trim and shape tall, hard-
to reach hedges and bushes with its extended reach and pivoting power head. You can
also adjust the Telescopic Trimmer to trim and shape smaller hedges and shrubs near
the ground without having to bend or stoop.
To use the Telescopic Trimmer for trimming tall, hard-to-reach hedges or shrubs, hold
the Telescopic Trimmer at the positions shown. Pivot the power head to several different
positions to shape or sculpt shrubs or hedges (Fig. H).
To use the Telescopic Trimmer for trimming smaller hedges or shrubs, hold the Telescopic
Trimmer at the positions as shown (Fig. I).
To use the Telescopic Trimmer for trimming the bottoms and sides of hedges and shrubs,
hold the Telescopic Trimmer at the positions as shown (Fig. J).
To use the Telescopic Trimmer for trimming low lying foliage or ground cover, hold the
Telescopic Trimmer at the position as shown (Fig. K).
Use the Telescopic Trimmer properly. Always wear eye protection, rubber gloves, and
substantial foot wear while using the Telescopic Trimmer. Always maintain proper footing
and balance and never overreach when using Telescopic Trimmer.
Before starting the Telescopic Trimmer, hold the tool with both hands on the grip areas.
Make sure that the cutter blade is not touching anything.
Do not try to cut too much at one time. This can cause the Telescopic Trimmer to slow
down or get jammed, reducing the cutting efficiency.
Do not force the Telescopic Trimmer through dense growth. A slight back and forth
sawing action may ease the cutting of larger, more dense growth. If the Telescopic
Trimmer begins to slow down or becomes jammed, immediately turn Telescopic Trimmer
off and remove the battery pack off. Wait for the cutting blade to cool before removing
any blockage.
Do not try to cut branches larger than 18mm in diameter.
For best results, trim the sides of hedges with an upward sweeping motion. Trim the
hedges so that the top is slightly narrower than the bottom.
