Device Not Found
If for some reason the Device Installer cannot find the DL4500 on the Ethernet network,
follow the steps below.
1.
Click the Assign IP button and the following screen will appear.
2.
Enter MAC address of the DL4500 and click Next. This can be found on the bottom
of the DL4500. The Device Installer should now find the device. Now follow the
steps at the beginning of the
IP Address
section to assign an IP address. If for some
reason the device still cannot be found, see section
9.1 Device Installer Cannot Find
the DL4500
.
5.1.2 Telnet
After the IP address of the DL4500 is assigned, the internal communication parameters
that the Lantronix daughter board uses to communicate with the DL4500 motherboard
must be configured. Depending on the model of DL4500 that is being used, there are
different Telnet settings that must be set. The Telnet settings for each model of DL4500
are shown below in the following order:
DF1 MultiMaster
,
Standard Tunnel
, and
Modbus
TCP
.
To start a telnet session, there are two ways that can be used. The first method uses the
Device Installer while the second uses a DOS command prompt.
#815-1200 W73rd Ave, Vancouver, BC, V6P6G5, Canada Phone: 888-387-3787 or 604-266-8547 www.equustek.com
16
