Mounting on Open Trailers
Mounting holes
for open trailers
1. Select a location on your trailer for your blower (If you want to put the rack on the side rail but at
the very front of the trailer you can pivot the tube holder toward the back to keep the tube from
sticking out over the front of the trailer.
2. Set the rack onto the rail and mark the location of the holes.
3. Drill the holes using a 27/64 drill bit.
Mounting on Enclosed Trailers
Holes for mounting
on a wall
•
Use the holes indicated for mounting on a wall. Make sure and use all holes/screws.
•
All of the holes in the center should be screwed directly into a steel rib.
•
If the tube support arm doesn’t allow the tube to lay where you want it on the wall, screw the tube
holder directly onto the wall in the necessary location.
The tube holder assembly
can be raised and lowered
and pivoted front to back
as needed.
If the tube support arm
doesn’t allow the tube to
lay where you want it on
the wall, screw the tube
holder directly onto the
wall in the necessary
location. To mount directly
on the wall use two self
drilling/tapping screws
with the flat washers
(included.)
Hardware Packet Labeled:
Enclosed Trailer mounting
hardware
Qty 10
Qty 2
Hardware Packet Labeled:
Open Trailer mounting
hardware
Qty 2
Qty 2
Qty 2
Qty 2
Used with a screw
to mount tube
holder on the wall.
