Equinox Systems Shard, User Manual

Page: 7 / 12

www.prolight.co.uk Shard User Manual
7
Operating instructions
Master/slave mode:
To set the master unit, press the “MENU” button and use the “UP” and “DOWN” buttons on the rear
of the unit to show
SLNd
on the LED display. Now press the “ENTER” button and use the “UP” and
“DOWN” buttons to choose
Nast
. Press the “ENTER” button to confirm the setting.
Then select your desired program.
To set the other units in slave mode, press the
“MENU” button and use the “UP” and “DOWN” buttons
on the rear of the unit to show
SLNd
on the LED display. Now press the “ENTER” button and use the
“UP” and “DOWN” buttons to choose either
SL 1
~
SL 2
. Press the “ENTER” button to confirm the
setting. The unit will now run in sequence with the master unit.
To exit out of any of the above options, press the
“MENU” button.
Please ensure that all slave units are set to the same DMX channel mode as the master unit.
Show mode:
To access the show modes, press the “MENU” button and use the “UP” and “DOWN” buttons on the rear
of the unit to show
ShNd
on the LED display. Now press the “ENTER” button and use the “UP” and
“DOWN” buttons to choose between
Sh 0
~
Sh 8
. Press the “ENTER” button to confirm the setting.
To exit out of any of the above options, press the “MENU” button.
Please note: Show 0 is a random show mode where it runs through all the other build-in shows.
All shows apart from Show 2 react to sound. Show 2 is a slow moving colour change show
which doesn’t react to sound.
Sound active:
To access the sound active setting, press the “MENU” button and use the “UP” and “DOWN” buttons on
the rear of the unit to show
SoUn
on the LED display. Now press the “ENTER” button and use the “UP”
and “DOWN” buttons to choose between
on
or
ofF
. Press the “ENTER” button to confirm the setting.
To exit out of any of the above options, press the “MENU” button.
Sound sensitivity:
To adjust the sound sensitivity, press the “MENU” button and use the “UP” and “DOWN” buttons on the
rear of the unit to show
Sens
on the LED display. Now press the “ENTER” button and use the “UP”
and “DOWN” buttons to choose between
0
~
100
. Press the “ENTER” button to confirm the setting.
Value: 0 - 100 (0 = low, 100 = high)
To exit out of any of the above options, press the “MENU” button.