Reset
Press the MENU button to select
. Press the ENTER button and all
channels of the unit will return to their standard position.
4. How To Control The Unit
1. Master/slave built-in preprogram function
2. Universal DMX controller
There is no need to turn the unit off when you change the DMX address as
new DMX address setting will be effected at once. Every time you turn the
unit on, it will show “
”on the display and move all the motors to their
‘home’ position and you may hear some noises for about 20 seconds. After
that the unit will be ready to receive a DMX signal or run the built in
programs.
4.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control
the other units to give an automatic, sound activated, synchronized light
show. This function is good when you want an instant show. You have to
set the first unit as master and select show 1, show 2, show 3 or show
4 from the Show Mode. The other units must be set to either Slave 1
(normal) or Slave 2 (2 light show) mode. A DMX cable between the units
for daisy chaining is needed.
2-light show
In slave mode, Slave 1 means the unit works normally and Slave 2
means 2-light show. In order to create a great light show, you can set
Slave 2 on the second unit to get contrast movement to each other, even
if you have two units only.
4.2 CA-8 Controller
Your Slender Beam Quad Bar can be controlled using the optional CA-8
easy controller (order code CONT10)
BLACKOUT: The fixture can be blacked out by pressing the STANDBY
button. To turn the fixture back on simply press the STANDBY button
again.
MODE (LED OFF): In this mode repeated pressing of the FUNCTION
button will trigger the movement of the heads without any music playing.
MODE (LED FULL ON): In this mode by pressing the FUNCTION button
you can scroll through the four built-in light shows.
MODE (LED SLOW FLASHING): In this mode you can select the speed of
the auto movements. Nine speeds are available (slow>fast)
MODE (LED FAST FLASHING): In this mode you can select the colour of
the heads. Fifteen colours are available.
4.3 DMX Controller
By using a universal DMX controller to control the units, you will need to
set a DMX address from 1 to 512 so that the units can receive a DMX signal.
Press the MENU button until
is showing on the display. Press the
ENTER button and the display will blink. Use the DOWN and UP buttons to
change the DMX-512 address. Once the address has been selected, press
the ENTER button to confirm. To go back to the functions without any
changes press the MENU button again. Press and hold the MENU button
one second or wait for one minute to go back to the main menu.
