INSTALLATION INSTRUCTIONS
Exhaust Materials
NOTE:To reduce the risk of fire, DO NOT use flexible
plastic pipe to exhaust the dryer. The following exhaust
materials are recommended and can be obtained from
any local hardware store:
4.1
4"(Diameter) Rigid metal duct.
4.2 4"(Diameter) Non-combustable semi-rigid
flexible metal duct.
4.3
IMPORTANT: For maximum efficiency, keep the
exhaust duct as short as possible.Make sure old exhaust
ducts are 'cleaned' before installing your new dryer.
4.4
To prevent "backdraft" when the dryer is not in use,the
outer end of the exhaust pipe must have a weather hood
with hinged dampers installed.(Available at local hardware
stores).
Note:
Weather hood should be installed at least 12"
(30.5cm) above the ground. Higher clearances may be
necessary in areas where heavy snowfall can occur.
INSTALLATION
5.1
Before installation,we recommend a thorough visual
inspection of the dryer for damage.Do not install the dryer
if the appliance is damaged.
5.2
The dryer is equipped with an exhaust adapter which
will accept standard 4" (10.2 cm) diameter rigid or flexible
metal exhaust pipe.
5.3
Mount the adapter to the cabinet (Fig 2) using the
sheet metal screws provided.
5.4
The dryer must be installed on a solid floor and
adequate ventilation provided.
5.5 Warning!
The dryer should not be exhausted into a
chimney, a wall, a ceiling, or a concealed part of the
building.
5.6 Warning!
To reduce the risk of fire, this appliance
must be exhausted outdoors.
5.7
Try and place the dryer so the exhaust pipe is as
short as possible. (Fig 3)
5.8
Use as few 90º elbows as possible.
5.9
Use duct tape (not screws) to seal all joints.
5.10
Make sure that the air inlets at the back of the dryer
are not blocked and do not allow lint to accumulate
around the dryer.
5.11
To level the dryer, adjust the two (2) leveling legs front of the dryer
5.12
Install the lint filter into position, as shown in Fig (4).
5.13
Plug the electrical power cord(supplied with the dryer) into an approved receptacle mounted on the wall
adjacent to the dryer. 3
Never operate the dryer without
the lint filter in place.
