Equalizer International SWi12/14TM, Operator'S Instruction Manual

Page: 15 / 40

OPERATOR INSTRUCTION MANUAL
IM_SWi_REV07_A4_English
SWi12/14TM; SWi20/25TE; SWi20/25TI
FLANGE SPREADING WEDGES
15
6.3
SWi20/25TI KIT CONTENTS
STANDARD KIT
Product Code: SWi2025TISTDSPB
1 x SWi20/25TI Flange Spreader Wedgehead
1 x 10,000psi (700bar) Integral Hydraulic Pump/Cylinder
1 x Set of Safety Blocks
1 x Pair of Stepped Blocks
1 x Lanyard
1 x Hex Key
1 x Carry-Strap
1 x Instruction Manual
1 x Carry Case
580mm x 330mm x 165mm (22.8” x 13.0” x 6.5”)
Gross kit Weight 13.8kg (30.4lb)
Tool only weight: 8.5kg (18.7lb)
6.4
SWi20/25TI DIMENSIONS
60mm
(2.4”)
152mm
(6.0”)
6.0mm
(0.24”)
465mm
(18.3”)
TOOL DIMENSIONS
- CLOSED
AIR RELIEF INSTRUCTIONS
In the event of air build-up within the cylinder-pump
subassembly, the following procedure should be executed:
Select advance (+), and pump the handle to extend the
piston around 30mm (1.2”). Remove the Oil Fill Screw
using an appropriate hex key, ensuring the tool is on its
side with the Oil Fill facing upwards (top photo).
Replenish any missing hydraulic oil by pouring into the Oil
Fill hole until excess spills over (middle photo).
Sit the tool with the wedge facing uphill (and the open Oil
Fill hole still facing upwards) on a gentle slope, around 30
degrees from horizontal.
Very slowly move the selector from advance (+) to retract
(-), and wait for the tool to fully retract (lower photo).
Replace the Oil Fill Screw.
Repeat this procedure 3 times.