FLANGE ALIGNMENT TOOLS
OPERATOR INSTRUCTION MANUAL
PAGE 24
4
.
Remove the circlip using a circlip
pliers (not illustrated)
5
.
Remove the shaft and two bearings.
Inspect the bearing housing, shaft,
and needle bearings for any sign
of damage, dirt or grit. Clean then
smear a small amount of grease
onto the shaft and into the needle
bearings.
Recomended grease - Rocol or
Saphire Hi-Load.
6.
Remove the spirol retaining clips
from the lower shaft and slide the
shaft out from the main body.
The roller and needle bearing can be
removed through the upper section
of the tool as shown.
Inspect the roller, shaft and needle
bearings for any sign of damage,
dirt or grit. Clean and then smear a
small amount of grease onto the
shaft and into the needle bearings.
Recommended grease -
Rocol Sapphire Hi-Load
or equivalent Hi-Load Bearing
grease
7.
Re-assemble by reversing steps 2-6.
