44
Start-up
• Place the electronic unit
(C)
of the CO2 sensor
into the clip-on frame so that the contacts of the
electronic unit latch into the voltage supply unit
(
see figure 8 or 9
).
• Switch the fuse of the power circuit on again to
activate the teach-in mode of the device (
see fig-
ure 10
) (see “5.1 Installation instructions” on page
5.3
Teaching-in
Read this entire section before starting the
teach-in procedure.
First set up your Homematic IP Access Point via
the Homematic IP app to enable operation of
other Homematic IP devices within your system.
For further information, refer to the operating
manual of the Access Point.
You can connect the device either to the Access
Point or to the Homematic Central Control Unit
CCU2/CCU3. For detailed information, refer to the
Homematic IP User Guide, available for download
in the download area of www.homematic-ip.com.
To integrate the device into your system and enable it to
communicate with other Homematic IP devices, it has to
be connected to your Homematic IP Access Point first.
Summary of Contents for homematic IP HmIP-SCTH230
