QX5
QXFXO4/QXISDN4/QXE1T1/QXFXS24; (SW Version 6.0.x)
68
QXFXO4/QXISDN4/QXE1T1/QXFXS24 Manual II: Administrator’s Guide
UDP Parameters
:
Manipulation radio buttons allow you to select the type of
connection over NAT:
Selecting
Use STUN
will switch to automatic discovery of
Mapped settings for the SIP UDP traffic over NAT. STUN settings
are configured on the STUN parameters page (see below).
Selecting
Use Manual NAT Traversal
allows you to manually
define the mapped settings for the SIP UDP traffic over NAT:
Mapped Hos
t requires the IP address of the mapped host for
SIP UDP traffic over NAT.
Mapped Port
requires the port number on the mapped host for
the SIP UDP traffic over NAT.
Fig.II- 83: NAT traversal Settings - SIP Parameters page
TCP/TLS Parameters:
Mapped TCP Host
requires the IP address of the mapped host for SIP TCP traffic over NAT.
Mapped TCP Port
requires the port number on the mapped host for the SIP TCP traffic over NAT.
Mapped TLS Host
requires the IP address of the mapped host for SIP TLS traffic over NAT.
Mapped TLS Port
requires the port number on the mapped host for the SIP TLS traffic over NAT.
RTP Parameters
The
RTP Parameters
page is used to choose between the STUN and Manual NAT traversal connection for the RTP traffic and to define the RTP/RTCP
ports for the connection over NAT.
Manipulation radio buttons allow you to select the type of connection over NAT:
Selecting
Use STUN
will switch to automatic discovery of Mapped settings for the RTP UDP traffic over NAT. STUN settings are configured on the STUN
Parameters page (see below).
Selecting
Use Manual NAT Traversal
allows you to manually
define the RTP/RTCP port ranges for the RTP traffic over NAT:
•
The
Mapped Host
text fields require the Mapped Host for
RTP traffic over NAT.
•
Mapped RTP/RTCP Port Range:
•
Min
- minimal port has to be higher than 1024 and lower
than the maximal port range. Only even numbers are
allowed.
•
Max
- maximal port has to be lower than 65536 and higher
than the minimal port range. Only odd numbers are
allowed.
Please Note:
RTP/RTCP Mapped Port ranges should be greater
than or equal to the RTP/RTCP port ranges defined on the
page.
Fig.II- 84: NAT traversal Settings - RTP Parameters page
