U-00249 7
Connect edge trim frames (
e/f
) together using the
Center Joints- M4(a)
and secure with four of the
M4x4 Screws (m)
as shown in
Step 1
. Repeat for other side.
Once both top and bottom edge trim frames have been connected, attach the vertical (left/right) sides edge trim
frames (
d
) using the
Elbow Joints M4(c)
and secure with four
M4x4 screws
(
m
) on all corners,
Step 2
.
Step 12
: Install the
angle cover
(
n
) on each corner of the frame as show in the illustration below.
Step 13
: Install the
springs (q)
in each middle area to secure the bezel trim edge frame.
Wall Installation
Step 14:
Measure the overall length and height of the frame and drill holes for the top brackets. Line up the wall
brackets with the drilled holes on the installation location and screw them in using a Phillips screwdriver. If not
installing into a structural wood stud, use a hollow wall anchor then screw in the M5x50 wood screws with a
screwdriver. Make sure the brackets are leveled.
c.
a.
m.
2.
1.
1.
2.
2.
screen
sc
re
en
2.
1.
m.
.
1.
2.
2.
n.
Peel off the double-sided tape.
q.
j.
e.
k.
k.
