-18-
CORRECT USE
Warning!
Don’t put bottles or other glass containers in the freezer compartment as they might crack or break
when the contents are defrosted.
Warning!
It’s absolutely forbidden to place the product in the tanks over the max load level.
PUTTING INTO OPERATION
If the cabinet has been sharply tilted while being sited or for mounting of accessories,
it must be left to stand for at least three hours before being started to allow the
lubricating oil to settle in the compressor.
Failure to do so can cause total destruction of the compressor refrigerating system.
Check that the voltage on the identification plate is the same as that of the network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE REFRIGERATOR WILL HAVE
TO BE CONNECTED IS TO BE PROTECTED BY A VERY SENSITIVE DIFFERENTIAL
SWITCH (Rc=16A,Dc=30mA); IT IS ALSO TO BE LINKED TO THE GENERAL
EARTHING PLANT.
ollow the manufacturer’s instructions to
install the unit, using qualified personnel and
complying with the electrical regulations for
the specific country.
Incorrect installation may cause injury and
damage; the manufacturer is not liable for this.
The manufacturer disclaims all responsability
for any damage to people or
things due to
incorrect observance of this rule.
Earthing is necessary and compulsory by
law.
Absolutely never use reduction units, patch
cords, adapters or multiple socket outlets to
connect the counter. DIRECTLY connect
the equipment to the mains.
The cable should be fully extended and located
where it is unilikely to be struck, caught or
stepped on, away from water and the other
liquids and heat sources and must not be
damaged.
In case of breakage of the power cable of the cabinet, it must be replaced by the manufacturer or by
instruction it change of it. The plug must still be accessible even after installing the unit.
