-14-
8.4
PUTTING INTO OPERATION
If the cabinet has been sharply tilted while being sited or for mounting of accessories, it must be left to
stand for at least three hours before being started to allow the lubricating oil to settle in the compressor.
Failure to do so can cause total destruction of the compressor refrigerating system.
Check that the voltage on the identification plate is the same as that of the network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE REFRIGERATOR WILL HAVE TO BE CONNECTED IS TO
BE PROTECTED BY A VERY SENSITIVE DIFFERENTIAL SWITCH (Rc=16A,Dc=30mA); IT IS ALSO TO BE
LINKED TO THE GENERAL EARTHING PLANT.
Follow the manufacturer’s instructions to install the unit, using qualified personnel and complying with the
electrical regulations for the specific country.
Incorrect installation may cause injury and damage; the manufacturer is not liable for this.
The manufacturer disclaims all responsability for any damage to people or things due to incorrect
observance of this rule.
Earthing is necessary and compulsory by law. Absolutely never use reduction units, patch cords, adapters
or multiple socket outlets to connect the counter. DIRECTLY connect the equipment to the mains.
The cable should be fully extended and located where it is unilikely to be struck, caught or stepped on,
away from water and the other liquids and heat sources and must not be damaged.
In case of breakage of the power cable of the cabinet, it must be replaced by the manufacturer or by
instruction it change of it.
8.5
PERIODIC MAINTENANCE
WARNING!
ANY WORK CARRIED OUT ON THE APPLIANCE BY THE USER STRICTLY REQUIRES
THE POWER PLUG BEING DISCONNECTED FROM THE MAINS SOCKET.
Inspect the power cable to see if it is damaged. If the power cable is damaged, do not use the appliance and
try to repair it: it must be replaced by the manufacturer or its customer service department or by a similarly
qualified person, in order to prevent any risks. No protection (grill or guard) should be removed by unqualified personnel
and strictly avoid operating the appliance with these protections removed.
Any other maintenance operation not planned in the previous points should be carried out
by the support centres authorised by our dealers or by qualified staff.
Never call on unauthorized technicians and always refuse spare parts which are not originals.
9.
CLEANING
For a good preservation of the cabinet’s body a periodical cleaning is necessary.
EXTERNAL BODY:
When necessary, the external body should be cleaned with a cloth and a neutral soap and water solution.
STAINLESS STEEL SURFACES:
wash with warm water and mild detergent, rinse well and dry with soft cloth. Avoid scouring
pads etc. which will spoil the finish of the stainless steel.
SURFACES IN PLASTIC MATERIAL:
wash with warm water and mild detergent, rinse well and dry with soft cloth; under no
circumstances should alcohol, methylated spirits or solvents be used.
GLASS SURFACES:
only use products specifically designed for glass cleaning; It is not advisable to use ordinary water which
can leave a film of calcium on the surface of the glass.
9.1
OUTER CLEANING
