TM-U295 Installation Manual 7
English
Attaching the Transportation Damper
If you ever ship or store your printer, prepare it by performing these
steps:
1.
Make sure that the printer is turned on.
2.
Press the
RELEASE
button.
3.
Press the
FORWARD
button.
4.
Turn off the printer.
5.
Put the transportation damper back where it was when you
received the printer.
Connecting the Printer to the Computer
You need an appropriate serial interface cable to connect your
computer to the printer.
1. Make sure that the printer and the computer are turned off.
2.
Plug the serial interface cable into the interface connector on the
back of the printer, as shown.
3.
Tighten the screws of the serial interface cable connector.
Note:
Your printer comes with inch-type hexagonal lock screws installed. If you
plan to use an interface cable that requires millimeter-type lock screws,
replace the inch-type screws with the enclosed millimeter-type screws by
using a hex screwdriver (5 mm). To distinguish the two types of screws, see
the illustration below; the screw on the right is the millimeter type.
4. Connect the other end of the cable to the connector on your
computer.
Notch (one or more line
s
)
Millimeter-type
Inch-type
