Setting Up the Printer 1–17
Running the Self Test
Any time that you want to check the performance of your printer
you can run the self test described below. This shows whether your
printer is working correctly. It is independent of any other
equipment or software.
Note:
Be sure to install the ribbon cassette and the paper roll before
you run the self test.
1. To perform the self test, hold down the
PAPER FEED
button
while you turn on the printer with the power switch.
2. The printer prints the current printer settings and then the
PAPER OUT
light blinks to indicate that the printer is in the test
printing standby state.
3. Press the
PAPER FEED
button to start the second part of the test,
in which the printer prints a pattern using the built-in character
set.
4. After the printer completes a certain number of lines, it prints
the following:
*** completed ***
Then it enters the normal mode.
Note:
If you want to pause the self test manually, press the
PAPER
FEED
button. Press the
PAPER FEED
button again to continue
the self test.
Summary of Contents for TM-U200D series
Page 2: ...1 Station Printer TM U200D Series Operator s Manual 401238900 ...
Page 11: ...viii ...
Page 37: ...2 4 Using the Printer ...
Page 52: ......
