Epson TM-U200D series, Operator'S Manual

Page: 16 / 53

Setting Up the Printer 1–5
Note:
Your printer comes with inch-type hexagonal lock screws installed.
If you plan to use an interface cable that requires millimeter-type
lock screws, replace the inch-type screws with the enclosed
millimeter-type screws by using a hex screwdriver (5 mm). To
distinguish the two types of screws, see the illustration below .
2. Connect the other end of the cable to the connector on your
computer.
Model with parallel interface
1. Make sure that the printer and the computer are turned off.
Then plug the cable into the connector on the printer, as shown.
Note:
Squeeze the wire clips on the printer together until they lock in
place on both sides of the connector.
2. Connect the other end of the cable to the connector on your
computer.
Notch (one or more lines)
Millimeter-type Inch-type