Epson TM-T70II, Technical Reference Manual

Page: 57 / 156

Chapter 2 Setup
57
2
Depe n d ing o n t he paper t ype, it i s recomme n ded t o se t t he pr int de n s it y as show n in t he t able
below for t he bes t pr int q u al it y.
Multi-tone print density
Selec t able from levels 1 t o 13 (70%

130%)
I niti al se tting for ANK models: level 7 (100%)
I niti al se tting for S i mpl i f i ed Ch in ese models, Trad iti o n al Ch in ese models, a n d So ut h As i a fo nt
models: level 11 (120%)
Print speed
Selec t able from levels 1 t o 13 (Slow

Fas t )
I niti al se tting : level 13
Thai character print mode (only for South Asia font models)
• Tha i 3 pass
• Tha i 1 pass ( initi al se tting )
Selecting the number of head energizing parts
• O n e-par t e n er gi z ing ( initi al se tting )
• Two-par t e n er gi z ing
Original Paper type Density Level
TF50KS-E, P220AGB-1, AF50KS-E Level 5 (90%)
TF60KS-E, PD160R, PD190R, KT48F20, KT55F20,
F5041
Level 7 (100%)
P300, P310, P350 Level 8 (105%)
When the print density level is increased, printing speed may be reduced.

First change the print density, and then configure the Multi-tone print density.

If you set the density too high, the contrast becomes lower. Select the density level
checking the overall tone balance of your image.
Depending on print conditions, such as print duty, print head temperature, and data
transmission speed, print speed is automatically adjusted, which may cause white lines due
to intermittent print (the motor sometimes stops). To avoid this, keep the print speed
constant by setting it lower, or set the transmission speed higher for the serial interface.