Epson SureColor SC-S30610, Technical Manual

Page: 8 / 26

Epson Engineering Europe SC ‐ S30600/610 Technical Guide P a g e | 8
STEP A MEDIA SELECTION
Note : this section will give detailed explanation for each settings with important effect on quality
A1 Media Selection
Just after lowered the Paper Pressure Lever, the printer will display the settings you can use for the media previously
loaded. If you have already created a custom Media and want to use it, then select [ Change Settings ] to select the
correct media or select [ RIP Settings ].
A2 What to use : RIP Settings or Custom Paper xx ?
Each time you load a media Roll, the printer will prompt a message to select the media Type. You have 2 possibilities:
choosing RIP settings or .select a Custom Paper xx.
● By choosing RIP settings , you decide to manage all media settings and quality settings FROM the RIP. The image
and media settings previously set in the RIP software will be sent to the printer.
● By choosing a Custom Paper xx , you decide that the printer manages all media settings. The RIP will send only
the print job and the resolution chosen in the RIP software.
STEP B Customizing [RIP Settings]
Note : [RIP Settings] will apply all the following settings for any type of media loaded and used
B1. Platen Gap
The platen gap is the gap between the print head surface and the media and not the Media and the print head.
Depending on the media thickness, set the correct platen gap to avoid head strike. On SC ‐ S30600/610, you can set
the gap from 1.5 (std value) to 2.5. For all media, the platen gap will have an important effect on print quality.
Tips
: If you wish to optimise the output quality, try to use other platen gap settings.
! Information
Remaining Setup : ON
Select Media
0 RIP Settings
● Keep Se ngs Above
● Change Se ngs
[OK] Proceed
Select Media :
● RIP Se ngs
● Media 1
● Media 2
● Media 3
● etc up to 30
[OK] Proceed
RIP Settings :
● Platen Gap (1,5, 2, 2,5)
● Head Alignment
● Roll Type (Side In, Side Out)
● Tension Measurement
● Media Tension