Epson Stylus Pro 7000 Series, Service Manual, Page: 194 / 231

EPSON Stylus Pro 7000 Revision B
Adjustment Self-Diagnostic Mode Menus 194
COUNTER CLEAR
This function resets (to the original condition) the following counters which
are stored in memory on the Main Board.
Note *: "1" means the flag is set, and the next time power is turned on the printer
will perform an initial ink charge.
5.4.3 Cleaning Menu
Using this menu you can select a cleaning mode and initiate that cleaning
operation. Also you can select whether or not the printer performs the initial-
cleaning cycle as well as forcefully start the initial-cleaning cycle.
Figure 5-41. Cleaning Menu Options
†
Std. KK0 (CL1)
Normal cleaning cycle
Volume of ink cleared = low
†
Std. KK1 (CL1’)
Strong cleaning cycle
Volume of ink cleared = medium
rubbing = off
†
Std. KK2 (CL2)
Strong cleaning cycle
Volume of ink cleared = high
rubbing = on
†
Init. Fill Perform Initial charge sequence
Table 5-14. Counters Reset by "Counter Clear"
Counter Reset Value
Protection Counter A/B 0
Ink Volume Counter Rb/ Ry/ Rx/Rz 0
Consumed Ink Counter Cb/ Cy/ Cm/ Cc/ Cll/ Clc 0
Power Cutoff Timer T2 0
Accumulated Prints Timer 0
CL Timer 0
CL Timer 3 0
CL Flag 0
Initial Charge Flag 1*
Periodic Pseudo-Vacuum Flag 0
C A U T I O N
Before clearing the Waste Ink Counter or the Consumed Ink
Counter, make sure you replace the following parts with new
parts.
„
Waste Ink Pads
„
Flush Box
„
Pump Assembly
„
Cap Assembly
„
Head Cleaner
The above parts are provided as [Maintenance Kit, SP-7000
1054038].
[Pause] returns you
to previous menu
[SelecType]
[Item]
[Enter]
Start the
cleaning cycle
Cleaning: Std. KK0
Cleaning: Std. KK1
Cleaning: Std. KK2
Cleaning: Init. Fill