Epson Stylus Pro 7000 Series, Service Manual, Page: 110 / 231

EPSON Stylus Pro 7000 Revision B
Disassembly & Assembly Summary 110
Figure 4-1. Directional View of the Printer
4.1.2 Tools
This section lists the tools necessary to disassemble or assemble the printer.
C H E C K
P O I N T
„
If you find it is necessary to perform service on a part not
described in this chapter, be sure to check the after-
service parts situation before beginning the service.
„
If you need to remove the ink tubes or other ink related
parts, see “Transportation Mode” on page 53 to drain the
ink before removing anything.
„
If necessary (i.e. when transporting the printer) use the
above mentioned mode to drain ink, install transportation
fluid cartridges (P/N1045585), and then perform an initial
ink charge with the fluid. Enter the transportation mode
again to remove the fluid (user can do) and then perform
initial ink charge with ink.
„
The directional instructions in this chapter are given as if
viewing the printer from the front. See the illustration
below.
Top
Bottom
Rear
Front
R
L
Table 4-1. Necessary Tools
Tool Part Code Notes
(+) Phillips screwdriver #2
commonly available
tools, no special tools
necessary
longer than 250mm is helpful
(+) Phillips screwdriver #1
(-) Standard screwdriver -
Round-nosed pliers -
Tweezers -
Hex (Allen key) wrench
Comes with stand,
commonly available
tools also OK
5.5 mm for stand assembly
only
#E589 torque wrench
(6mm x 1Kg)
B765106901 Tube lock tightener
#F733 Self Training Kit 1053426 CD-ROM based service tool
transportation fluid
cartridges, S46, recycle
1045585
Transportation fluid cartridges
= six units required
Maintenance Kit SP7000 1054038
Replacement parts for periodic
maintenance