Epson Stylus Pro 4800 Portrait Edition, Service Manual

Page: 318 / 506

EPSON Stylus Pro 4400/4450/4800/4880/4880C Revision C
Disassembly & Assembly Disassembly Procedures 318
7. While keeping the sheet turned aside, remove "Extension Spring, 0.262"
from the tabs of "Mount Assy., Plate, Motor, ASF, SP" and "Lever, Lock,
DE".
(Refer to Figure 4-156.)
8. Pull the "Lever, Lock, Planetary" toward the outside of the printer, release
the hook on top and then pull out of the "Lever, Lock, DE".
(Refer to Figure 4-157.)
Figure 4-156. Extension Spring, 0.262 Removal
Figure 4-157. Lever, Lock, Planetary Removal
C A U T I O N
When performing the following steps, be careful of the
points below.
„
Do not lose "Extension Spring, 0.262".
„
Use care not to pull "Extension Spring, 0.262" too much,
or it may loose the spring force.
„
Do not touch the "Cleaner, Head" or allow it to contact
other parts. (This could lower print quality due to not
wiping ink normally.)
After installing the "Lever, Lock, Planetary", confirm that
"Lever, Lock, DE" moves smoothly by the tension of
"Extension Spring, 0.262". (Check three times.)
Cleaner, Head
Sheet
Extension Spring, 0.262
Lever, Lock, DE
Tads
Lever, Lock, Planetary