Epson Stylus Photo RX640 series, Service Manual

Page: 49 / 103

EPSON Stylus PHOTO RX640/650 Revision A
Disassembly and Assembly Removal of Exterior Parts 49
(éüÇÃÉyÅ[ÉWÇ÷ë±Ç¦)
Figure 4-21. Routing the Harness 1
Figure 4-22. Routing the Harness 2
Figure 4-23. Routing the Printhead FFC
„
Check the following before installing the Middle Housing:
•
Stacker operates properly. (p.55)
•
The harness is routed properly. (Fig. 4-21) , (Fig. 4-22)
„
When installing the Middle Housing, check the following:
•
Printhead FFCs (x2) are lead out properly. (Fig. 4-23)
•
Ground Plate is located in front of printer frame. (Fig. 4-23)
•
The left and right bottom areas of the Front Housing are
engaged with the projections of Bottom Housing.
(Fig. 4-24)
•
The screws are tightened in the order specified. (Fig. 4-20)
Hooks
~Rear left~
~Left side~
~Rear right~
After setting the
ferrite cores in place,
stick the acetate tape.
Acetate Tape 18x20
Acetate Tape 18x20 (x6)
Hooks
Printhead FFC
Locate the tip of Ground
Plate on the front side
~Front side~
~Rear side~
Ground Plate