Epson Stylus Photo RX640 series, Service Manual

Page: 50 / 103

EPSON Stylus PHOTO RX640/650 Revision A
Disassembly and Assembly Removal of Exterior Parts 50
4.2.6 Waste Ink Tray Assy
1. Remove the Panel Assy (p.43)
2. Remove the Scanner Unit. (p. 45)
3. Remove the Middle Housing (p.48)
4. Remove the Waste Ink Tube from the Waste Ink Tray Assy. (Fig. 4-25 )
Figure 4-24. Checking the installation of the Middle Housing
Figure 4-25. Removing the Waste Ink Tray Assy
„
After installing the Middle Housing, check the following
conditions:
•
Waste Ink Tube is routed properly. (Fig. 4-24)
C A U T I O N
When removing the Waste Ink Tray Assy, take due care not to
stain any surrounding objects with waste ink.
„
When connecting the Waste Ink Tube, wipe the ink, if any, off
the joint area of the tube. With ink left adhering to the joint
area, the tube cannot be connected firmly and thus may easily
come off.
„
Route the Waste Ink Tube along the hooks of the Housing
Lower Assy, and take care that the tube is not flattened with
the Waste Ink Tray.
(Fig. 4-24)
A D J U S T M E N T
R E Q U I R E D
On the occasion of replacing a part with a new one, replace all the
specified parts with new ones and clear the counter value after
assembly.
„
5.1.1 Adjustment by Use of Adjustment Program (TBD) (p.72)
Projection
Projection
Groove for Waste Ink Tube
Hook
Hook
Waste Ink Tray Assy
Waste Ink Tube (to the I/S Assy)