6.
Slide the interface card along the slots on both sides of the interface
compartment. Push it in firmly to fully insert the connector at the rear
of the interface card into the printer’s internal socket.
7.
Secure the interface card in the slot with the two screws included with
the interface card.
8.
Connect the proper interface cable to the interface card and to your
computer. If the cable has a grounding wire, connect it with one of
the screws securing the parallel interface.
Also, if you are using more than one computer, reconnect the other
interface cable.
9.
Make sure the printer is turned off. Then plug in the power cord.
Before you use the optional interface, you may need to change the settings
for the interface option in the default-setting mode. If you need to change
any settings, see “Changing the default settings” on page 6-10 for
instructions.
To remove an interface card, follow the above steps in reverse order.
A-902
L
Loire-P Ref. Guide
Rev.c
A5 size
Appendix B
02-24-97
DR, pass 0
B-4
Using Optional Interfaces
Summary of Contents for Stylus COLOR 3000
