ADDENDUM
Stylus-800/1000 SERVICE MANUAL Disassembly and Assembly
3.1 Disassembly and Assembly
This addendum only explains the disassembly and assembly procedures
specifically applicable to the
3.1.1 Printer Mechanism M-4860 Removal
[Step 1]
[Step
2]
[Step 3]
[step 4]
[Step
5]
[Step
6]
[Step 71
[Step 8]
Remove the upper case. (Refer to Stylus-800 S/M (Section 3.2.1.))
Remove the power supply unit. (Refer to Stylus-800 S/M (Section 3.2.2.))
Remove
control circuit board unit. (Refer to Stylus-800 S/M (Section 3.2.3.))
Unhook two hooks of the center support of the auto sheet feeder from a front guide shaft, by lifting
up front edge of the center support. Then, remove the center support.
Remove the retaining ring (E-ring) from a front guide shaft.
Move the left edge guide assembly to the position shown in figure below, where two cutouts made
to the front paper guide frame (the paper eject support assembly is inserted to a rounded edge of
the paper guide frame assembly). Then, take out the paper exit support assembly.
Move the right edge guide assembly to the position
in the previous step and take out
the paper exit support assembly.
Remove the printer mechanism (M-4860) from the lower case.
cutout ‘
/
Front frame
guide
Paper eject
assembly
Figure 3-1 Printer Mechanism (M-4860) Removal
REV.-A 3 - 1
I
