Epson S5U1C17001C, Manual

Page: 624 / 742

S5U1C17001C ManUal
EPSOn
10-173
(C COMPilEr PaCkagE fOr S1C17 faMily) (Ver. 1.5.0)
10 DEBUggEr
10
Debugger
10.11.7 ES-Sim17 Error Massages
Table 10.11.7.1 Error messages (displayed in the gdb [Console] window)
Message Description
ES-Sim error 01 : Loading the dll file was failed. The dll file for ES-Sim17 does not exist in the default location or
cannot be loaded normally.
ES-Sim error 02 : Opening the CPU construction file
was failed. The CPU configuration file does not exist in the specified
location or cannot be loaded normally.
ES-Sim error 03 : Generating the CPU components
was failed. The
ES-Sim17
has failed generation of the CPU module as the
CPU module definition is incorrect or no required dll file exists.
ES-Sim error 04 : Connecting the CPU components
was failed. The ES-Sim17 has failed correction to the CPU module
generation as the connect destination in the CPU module
definition is incorrect.
ES-Sim error 05 : Opening the "user.ini" was failed. The user setting file does not exist in the specified location or
cannot be opened normally.
ES-Sim error 06 : Setting of the "user.ini" is invalid. The setting value written in the user setting file is incorrect.
Table 10.11.7.2 Error messages (displayed in a dialog box)
Message Description
Failed to save " path \ file ". The
ES-Sim17
has failed saving the captured image to the file.
Failed to open “path\file”.
Please confirm the file is fitting with the CPU type,
or the file is existing. The Lcd file could not be opened.
10.11.8 restrictions
• The ES-Sim17 supports the model shown below.
S1C17701
、
S1C17702
、
S1C17704
、
S1C17602
、
S1C17001
• The ES-Slim17 supports monochrome dot-matrix LCD and monochrome segment LCD panels as external
devices.
• The dot size, contrast, and panel color of the LCD window are different from those of the actual LCD panels.
• The
ES-Sim17
performs simulation on an instruction cycle basis. Therefore, operation cycles lower than the
instruction cycle cannot be simulated.
• The ES-Sim17 simulates the operation clock based on the instruction cycles. Therefore, the operation timings are
not the same as those of the actual hardware.
• The functions listed below cannot be simulated.
1. Timer clock and oscillation clock external outputs
2. Data transfer using the UART, I
2
C and SPI
3. Noise and chattering filters
• More than one ES-Sim17 cannot be run on a PC for simulation.
• Setting higher oscillation clock frequency causes degradation of simulation performance.
• The I/O control registers that are not supported by the ES-Sim17 function as general-purpose read/write registers.
Also they are not initialized at a reset.
• Some peripheral circuits, such as the oscillator and SVD circuits, need time until their operations stabilize. In the
simulation by the
ES-Sim17
, they can operate with stability immediately after they start.
*
For the restrictions in the latest version of
ES-Sim17
and model dependent restrictions, refer to "simulator_
readme.txt".