44
Making Detailed Adjustments
■
Direct Power On
Sets projection to start when the main power switch is turned on, without pressing the
P
power button on the remote control or the projector.
Note:
When Direct Power On is enabled, restoration of power after a power outage can cause
the projector to turn on.
■
Video Signal
Leave this setting on
Auto
so the projector can automatically interpret the format, such as
NTSC or PAL (for standard TV formats).
■
Component
Change this setting to match the type of equipment connected to the Component port.
For component video, select
Auto
to let the projector automatically interpret the signal;
or select
YCbCr
or
YPbPr
to manually select your video equipment’s signal.
■
HDMI1 EQ Setting
HDMI2 EQ Setting
If you’re using a long HDMI cable, you may have to select a higher setting to increase the
projector’s sensitivity to the incoming signal. You can select a separate setting for each of
the projector’s HDMI ports.
■
Trigger Out
Select
Power
to have the
Trigger out
port output a 12-volt signal to lower your
projection screen when the projector is running. Or select
Anamorphic Wide
to engage
a motorized anamorphic lens (commercially available) when the
Anamorphic Wide
or
Horiz. Squeeze
aspect ratio is selected.
Note:
If you change this setting, the new setting will take effect the next time you turn the
projector on.
■
Illumination
Turn off this setting to deactivate the lights on the projector’s
P
power button and power
light. Use this setting if you find the lights distracting in a darkened room.
Settings > Operation > Direct Power On
Settings > Input Signal > Video Signal
Settings > Input Signal > Component
Settings > Input Signal > HDMI1 EQ Setting or HDMI2 EQ Setting
Settings > Operation > Trigger Out
Settings > Operation > Illumination
