Connecting to a Computer
23
1. Connect the small end of the main cable to the projector’s
Mouse/Com 1
port. (Use the
Mouse/Com 2
port if you are
connecting a second computer.)
2. To use the remote control as a wireless mouse, connect the 9-pin
end of the PS/2 mouse cable included with the projector to the
MOUSE
terminal on the square end of the main cable.
3. Disconnect your mouse from the mouse port on the back of your
computer and replace it with the other end of the PS/2 mouse
cable included with the projector. (Your computer’s mouse will be
disabled while you are using the remote control as a mouse.)
Note:
If your system uses a serial mouse, perform steps 2 and 3 using
the PC mouse serial cable instead of the PS/2 mouse cable (not shown
in the illustration).
5300.book Page 23 Tuesday, April 13, 1999 4:19 PM
