Epson picturemate PM 310, User Manual

Page: 7 / 40

PictureMate PM 300 / PM 310 Safety Instructions
5
Englis
h
❏
Unplug the printer and the AC adapter, and refer servicing
to qualified service personnel under the following
conditions:
The power cord or plug is damaged; liquid has entered the
printer, remote controller, or AC adapter; the printer, remote
controller, or AC adapter has been dropped or the casing
damaged; the printer, remote controller, or AC adapter
does not operate normally or exhibits a distinct change in
performance. (Do not adjust controls that are not covered
by the operating instructions.)
❏
Do not use with wet hands.
❏
If damage occurs to the plug, replace the cord set or consult
a qualified electrician. If there are fuses in the plug, make
sure you replace them with fuses of the correct size and
rating.
❏
If you plan to use the AC adapter in Germany, the building
installation must be protected by a 10 or 16 amp circuit
breaker to provide adequate short-circuit protection and
over-current protection for this printer.
Note on handling the AC power cord for Singapore
users
Safety requirements
Mains plug:
Use a 2-pin mains plug that is certified to IEC 83 Standard C5.
Flexible cord:
Use a double insulated flexible cord that is certified* to the
relevant IEC or BS standards.
Appliance connector:
Use an appliance connector certified* to the relevant IEC320.
* certified by member of IECEE CB Scheme.
When using the printer
Observe the following when using the printer:
❏
If you use the printer in places where the use of electronic
devices is limited, such as in airplanes or hospitals, follow
all instructions in those places.
❏
Do not insert objects through the slots in the printer.
❏
Take care not to spill liquid on the printer, remote controller,
and AC adapter.
❏
Do not put your hand inside the printer or touch the photo
cartridge during printing.
❏
Do not use aerosol products that contain flammable gases
inside or around this product. Doing so may cause fire.
❏
Always turn the printer off using the
P
On
button. Do not
unplug the printer or turn off the power to the outlet until the
power light goes out.
❏
Before transporting the printer, make sure that the photo
cartridge is in place.
❏
Leave the photo cartridge installed. Removing the cartridge
can dehydrate the print head and may prevent the printer
from printing.