33
Chapter 2
Setup
2
Setting the DIP Switches
Follow
t
he s
t
eps below
t
o cha
ng
e
t
he DIP sw
it
ch se
tting
s.
Setting Procedure
Follow
t
he s
t
eps below
t
o cha
ng
e
t
he DIP sw
it
ch se
tting
s.
1
Make sure the power supply for the product is turned off.
2
Unscrew the screw to remove the DIP switch cover from the base of the
product.
3
Set the DIP switches, using a thin instrument such as a pair of tweezers.
4
Replace the DIP switch cover, and screw it in place.
CAUTION
Before you remove the DIP switch cover, turn the product off.
Otherwise, a short-circuit may cause the product to malfunction.
DIP switch settings are enabled only when the power is turned on or the product is reset via
the interface. If the settings are changed after that, the functions will not change.
DIP switch bank 1
DIP switch bank 2
Summary of Contents for OmniLink TM-T70-i
Page 26: ...26 ...